![]() If you have 1 type with both taps and Ts defined, it will change the pipe type, and even replace Ts with different Ts and Taps with different taps, without messing up all the connections. I currently have auto tapper enabled and I just checked my options and it is also greyed out. 'With Ts' or 'With Taps' are not a specified type of pipe or duct and will just make it more complicated if you need to make Bill of Quantities etc.Īlso its better to be able to select a whole run of pipe and do 'change type' or 'reapply type'. With type properties for material, fittings etc. Click on the plus so it makes the elbow into a T (The one in routing preferences will be used) and continue drawing. To make a T use the corner trim instead, so it makes an elbow. To make a tap, just trim onto the pipe or drag the end onto the pipe/duct. Then add a T (Just as you have done here with it greyed out) ![]() Make one type, with Tap as preferred junction type. Then, to turn off the Dashboard/Widgets access I went to 'Expose & Spaces' in System preferences and set. I downloaded MagicPrefs and set the 'One finger middle axis click' to 'middle click'. I was able to get the middle-button-pan function working using my Magic Mouse. Sometimes the light taps are opening 'new tabs' in chrome, sometimes not and its the same across the OS with any other browser/app not just chrome. For example I like to use taps to connect round duct to rectangular but Ts for round to round, but just have 1 type of round duct. I use Windows XP through Parallels to run AutoCAD 2010 with a Magic Mouse. You dont actually need to make separate duct/pipe types if you want to use both taps and tees.
0 Comments
Leave a Reply. |